Build your own rack mount server using the Intel SR2100 chassis and
the STL2 Server board + Quantum Atlas 10K Hard Drives (36GB SCSI
SCA)
| |
Click here to
subscribe to our Premium content area |
| This is page 5 |
Jump to Page: 1
2
3
4
5
6
7
8 |
| Here we are pointing out the chassis intrusion switch built
into the SR2100. Good thing as previous Intel Chassis we have built
required us to figure out how to mount this. |
 |
| Here is the chassis intrusion switch being conected to a
bank of pins that are about as far away as you can get from the switch.
(hmmm) |
 |
| Here we show the PCI riser card attached to the riser
retention bracket. Here is a tip for you, this is a good time to set the
processor speed jumper because once the riser is installed it is difficult
to get at the necessary jumpers. |
 |
| Here we show the riser installed into the SR2100
Chassis and the STL2 Server board. Our arrow is pointing at some flexible
circuit, make sure you don't put any pressure on this as it will break. |
 |
| Slightly different view with the riser card
re-installed |
 |
| Next Page |
Jump to Page: 1
2
3
4
5
6
7
8 |
| Questions?: Send us email |
